LaskaKit

Calibration and demonstration board for short-circuit finder kit, by @JiriDobry3

μŠup, STEMMA QT, Qwiic JST-SH 4-pin cable - 10cm

Simple line tracing robot kit Robot Ferret.

LaskaKit 2.7" 400x240 LCD Memory display monochrome

Our set of 37 sensors neatly arranged in a plastic box, which will simplify your start with arduino and allow you to experiment easily.

LaskaKit ACS711 current sensor, analog output. 15.5 or 31A

Directly designed for our AirBoard and Nova PM SDS011 Optical Air Quality Sensor

Directly designed for our AirBoard and Optical Air Quality Sensor Sensirion SEN 54 and SEN 55

Directly designed for our AirBoard and Optical Air Quality Sensor Sensirion SPS 30

Proximity and gesture sensor GY-9960LLC APDS-9960, RGB, I2C.

Our largest starter kit with a Arduino UNO or MEGA board and loads of displays, sensors and other peripherals.In the "Related files" tab you will find instructions and codes in...

Our intermediate starter kit with Arduino UNO board and lots of displays, sensors and other peripherals.In the "Related files" tab you will find instructions and codes in Czech...

Our little starter kit with a Arduino UNO board and lots of peripherals.In the "Related files" tab you will find instructions and codes in Czech language!

A ready-made PCB with which you can make your own shield for the Arduino Nano board.

Prototype board for creating your own Arduino UNO and Mega shields.

A ready-made printed circuit board that allows you to easily make your own shield for Arduino Uno and Mega boards.

Step-up boost converter 5V 0.6A, based on DIO6605B

Light intensity sensor BH1750

Our breakout board for BK80xx BK32xx bluetooth modules.

Our sensor combines temperature measurement between -40 and 80°C, pressure between 300-1100hPa and humidity up to 100% RH with the BME280 chip.

Accurate measurement of pressure, temperature and humidity - no weather station, indoor or outdoor, can do without it. The BME688 can also measure IAQ (Air Quality).

LaskaKit BMP280 Air pressure and temperature sensor

Universal programmer with USB-UART converter CP2102 intended for uploading firmware (not only) to development kits LaskaKit.