Data Storage & Transmission, Page 3

Module with extra EEPROM memory that does not reset with the board and can store information for a long time.

eMMC microSD memory reader

ESP Prog v1.0 programmer CH340 for ESP-01/S

ESP-Prog UART, JTAG programmer for ESP8266, ESP32, ESP32-S2, ESP32-S3 and ESP32-C3 microcontrollers.

Module for wireless serial communication via bluetooth between boards or motherboards and mobile phones or laptops with bluetooth.

The TX868-BLG-40 is a fiberglass antenna designed to operate in the 868 MHz band, with a length of approximately 400 mm and a straight male N-connector. Its fiberglass shell...

Miniature radio receiver module between frequencies 50MHz-115MHz. It is able to connect to the board using the I2C bus and on the other side it connects to the amplifier.

Miniature radio receiver module between 76MHz - 108MHz. It is able to connect to the board using the I2C bus and on the other side it connects to the amplifier.

FM radio module with its own antenna, which you are able to control using I2C bus with Arduino.

Antenna flexible 10dBi 16.7cm 868MHz is a special type of antenna designed for wireless communication in the 868 MHz band, which is often used for IoT (Internet of Things),...

GPRS GSM Module SIM800L microSIM, Quad-band, TTL

The module allows your board to communicate wirelessly using GPRS and GSM mobile networks. The module requires a prepaid microSIM card.

GPS positioning module, with its own ceramic antenna and additional eeprom memory.

GSM 39x15mm antenna 5dB U.FL (IPEX) connector

LTE 40x15mm antenna 5dB U.FL (IPEX1) connector

HTIT-Wsh (Wireless shell) is a LoRa node module with long range, high reception sensitivity and low power consumption (approx. 9uA). HTIT-Wsh consists of an MCU (ESP32-S3FN8)...

Heltec Mesh Node T114 V2.0 is a development board designed for low power consumption, which combines nRF52840 microcontroller and SX1262 LoRa chip, and supports LoRa and...

Heltec WiFi LoRa 32 V3 868Mhz 0.96" WiFi Module

Wireless Paper is a development kit with E-Ink display that offers multiple wireless control methods. In cooperation with sample programs and development tools, users can...

HTIT-Wsh (Wireless shell) is a LoRa node module with long range, high reception sensitivity and low power consumption (approx. 9uA). HTIT-Wsh consists of an MCU (ESP32-S3FN8)...

Heltec Wireless Stick Lite V3.1 868MHz SX1262 WiFi module is a highly integrated development module designed for wireless communication and IoT (Internet of Things)...

Wireless Tracker is a development kit based on ESP32-S3FN8. It integrates the SX1262 and UC6580 to provide a fast GNSS solution for IoT. It can track any object and then upload...

HopeRF RFM95W 868Mhz communication module

Module for wireless serial communication via bluetooth between boards or between a board and a mobile phone or laptop.