Arduino GPRS-GSM Shield SIM900

Product detailed description

GPRS / GSM Shield provides you with a way to use the GSM mobile network signal to receive data from a remote location with your Arduino board. It delivers GSM/GPRS 850/900/1800/1900 MHz signals for audio, SMS and GPRS. It is compatible with all boards that have the same shape (and pinout) as the standard Arduino series. The GPRS/GSM shield is configured and controlled via its UART port, using AT commands. GPRS Shield has 6 GPIO, 2 PWM and 1 ADC (all 2V8 logic) and can be controlled by AT commands directly from the controller. The kit includes a traditional sensitive GPRS antenna.

Note: In the instructions there is a slightly different shield, this shield does not have the possibility of SW switching with pin D9

Specifications:

• Quad-Band 850/900/1800/1900 MHz
• Power supply: 5V-20V
• GPRS multi-slot class 10/8
• GPRS mobile station (class B)
• Conforms to GSM phase 2/2 +
• Class 4 (2 W @ 850/900 MHz)
• Class 1 (1 W @ 1800/1900MHz)
• Control by AT commands (GSM 07,07, 07,05 and SIMCom extended AT commands)
• Low power consumption: 1.5 mA (sleep mode)
• Operating temperature: -40°C to +85°C
• 2-in-1 headset jack
• Embedded TCP/UDP stack - allows you to upload data to a web server.

Included in delivery:

• 1pc GPRS Shield PCBA
• 1pc Antenna

Remark:

• This product is not a standalone functional unit and may require professional installation.
• Product images are for illustration purposes only and may sometimes differ from the actual appearance of the item. However, this does not change its basic properties.
• After mounting the shield, please check that the pins from the bottom side do not touch the component housings on the bottom plate! This could cause a short circuit and destroy the shield or even the motherboard. Goods damaged in this way are not covered by the warranty!